Print 
PDF
The capacitive touch panel TFT allows manual operation of iris360
Power Button
The power button lets you power up and power down your iris360 camera.
To use the power button:
- Ensure the battery is charged, inserted and the On/Off switch is set to On
- Using your finger, press and hold the Power Button for 2 secs
Power Up Status Indicators
- The NCTech logo on the capacitive touch screen will illuminate after 2 seconds
- The LED status ring will illuminate Blue after approximately 1 min
- When the LED status ring illuminates blue, your camera is ready for use
Power Down Status Indicators
- The LED status ring will immediately turn Yellow
- After approx 25 secs the LED status ring and the capacitive touch screen will turn off
- When the LED status ring turns off, your iris360™ has powered down and you can toggle the On/Off Switch on the side of the camera to the Off position
Capture Button
The capture button allows you to capture an image.
To use the capture button:
- Ensure the battery is charged, inserted and the On/Off switch is set to On
- Using your finger, press and hold the Capture Button for 2 secs
Note: The capture will use the current settings stored on the camera.
Capture Status Indicators
- If Timer is enabled, the LED Status ring will illuminate flashing Blue during timer countdown
- During Capture the LED status ring will turn Off
- During Processing the LED status ring will illuminate solid Magenta
- After processing has complete the LED status ring will illuminate solid Blue
what does TFT stand for?
Thin-film-transistor liquid-crystal display